Foam control agent for water-based flat systems in low to high PVC
Appearance Opaque amber liquid Chemical type Mineral Hydrocarbons, silica, and surface active materials Water miscibility Low dispersibility Fluidity Viscosity not greater than 1000cPs @ 20° DIN 53019 100rpm Cleanliness No particles after screening through a 400μm aperture screen Specific gravity @20°C 0.88 – 0.93 g/ml Active content ~99 %
*This information shows typical properties and does not constitute a specification.
- Excellent defoamer
- Effective over a wide range of pH values
- Successful at low concentrations
- Performs well over a wide range of temperatures
- Helps with process productivity
- Low to high PVC systems
- Some low gloss paints, paper coatings, and plasters
- Wide range of aqueous systems
Borchi® Burst DFM 100 is usually added as received. It can be added at any time during production. In most cases the addition should be split between pigment grind and the let-down. A typical addition level would be between 0.1% and 0.5% in total depending on the severity of the foam problem. The optimum quantity and points of addition are determined by laboratory trials.
Store in closed containers. Avoid extremes of temperature, keep between 5°C and 30°C. Avoid freezing and do not store in direct sunlight. Product has a shelf life of 12 months, however during this time period some phasing may occur. Remixing will ensure the product is suitable for use.
Please refer to our safety data sheet for information relating to product safety.